POM DURACON SF-15

DURACON? is a crystalline thermoplastic acetal copolymer. The primary raw material trioxane, a trimer of formaldehyde.

The thermoplastic adopts a copolymer structure in which polyoxymethylene (-C-O) and carbon-carbon (-C-C- bond) comonomer groups are incorporated into its main chain. Therefore the copolymer has superior chemical and thermal stability, compared with acetal homopolymer.

Acetal co-polymer is well-balanced in terms of mechanical, chemical and thermal properties, and its superior moldability allows it to be widely employed in various industrial fields.

Information provided by PolyPlastics.

Physical Properties	Metric	English	Comments
Density	1.33g/cc	0.0480lb/in3	ISO 1183
Mechanical Properties	Metric	English	Comments
Tensile Strength, Ultimate	38.0MPa	5510psi	ISO 527-1, 2
Elongation at Break	100 %	100 %	ISO 527-1, 2
Tensile Modulus	1.70GPa	247ksi	ISO 527-1, 2
Flexural Strength	51.0MPa	7400psi	ISO 178
Flexural Modulus	1.50GPa	218ksi	ISO 178

特点

（1）POM加工前可不用干燥,最好在加工过程中进行预热(80℃左右),对产品尺寸的稳定性有好处.

（2） POM的加工温度很窄(0～215℃),在炮筒内停留时间稍长或温度超过220℃时就会分解,产生刺激性强的甲醛气体.

（3） POM料注塑时保压压力要较大(与注射压力相近),以减少压力降.螺杆转速不能过高,残量要少;

（4） POM产品收缩率较大,易产生缩水或变形.POM比热大,模温高(80～100℃),产品脱模时很烫,需防止烫伤手指.

（5） POM宜在“中压、中速、低料温、较高模温”的条件下成型加工,精密制品成型时需用控制模温

（6）具高机械强度和刚性

（7）最高的疲劳强度

（8）环境抵抗性、耐有机溶剂性佳

（9）耐反覆冲击性强,良好的电气性质,复原性良好,具自已润滑性、耐磨性良好,尺寸安定性优.

应用

.可代替大部分有色金属、汽车、机床、仪表内件、轴承、紧固件、齿轮、弹簧片、管道、运输带配件、电水煲、泵壳、沥水器、水龙头等.

POM DURACON SF-15 我司所销售所有产品均为原厂原包，均可提供相关资料报告（如：物性表，MSDS报告，UL报告，COA报告，SGS报告，FDA等）！