90C VIAIR空压机
92C VIAIR空压机
95C VIAIR空压机
97C VIAIR空压机
98C VIAIR空压机
100C VIAIR空压机
100C VIAIR空压机
无导管或止回阀
100C VIAIR空压机
www.fulies.com
275C VIAIR空压机
280C VIAIR空压机
325C VIAIR空压机
325C VIAIR空压机
无导管或止回阀
350C VIAIR空压机
380C VIAIR空压机
400C VIAIR空压机
420C VIAIR空压机
425C Gen. 2 VIAIR空压机
450C VIAIR空压机
460C VIAIR空压机
480C VIAIR空压机
485C Gen. 2 VIAIR空压机
    90C Compressor
    92C Compressor
    95C Compressor
    97C Compressor
    98C Compressor
    100C Compressor
    100C Compressor
    No Leader Hose or Check Valve
    100C Compressor
    w/Omega Bracket
    275C Compressor
    280C Compressor
    325C Compressor
    325C Compressor
    No Leader Hose or Check Valve
    350C Compressor
    380C Compressor
    400C Compressor
    420C Compressor
    425C Gen. 2 Compressor
    450C Compressor
    460C Compressor
    480C Compressor
    485C Gen. 2 Compressor
VIAIR “C” model compressors are intended to fill air tanks. They are not equipped with an ON/OFF switch or pressure sensitive shutoff device of any kind. The use of a pressure switch and relay are recommended and required. All “C” model VIAIR compressors (except certain 90 & 100 series units) are equipped with a stainless steel braided leader hose and a check valve to keep the compressor from restarting under pressure which can create an amp draw spike and can cause motor damage. Most VIAIR compressors are equipped with a thermal overload protector that will shut down the unit when overheated. When cool, the compressor will automatically restart as normal.

Note: • Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the air compressor. Always observe the MAXIMUM DUTY CYCLE of the air compressor. Operation exceeding maximum pressure ratings and/or duty cycle will result in damage to the air compressor.

VIAIR“C”型压缩机用于填充空气罐。 它们没有配备任何类型的ON / OFF开关或压力敏感关闭装置。 建议使用压力开关和继电器。 所有“C”型VIAIR压缩机（某些90和100系列单元除外）都配有不锈钢编织引导软管和止回阀，以防止压缩机在压力下重新启动，从而产生放大器拉伸尖峰并可能导致电机损坏。 大多数VIAIR压缩机都配有热过载保护器，过热时会关闭设备。 冷却后，压缩机将自动重启。

注意：•始终在压缩机的最大压力等级或以下运行压缩机。 始终遵守空气压缩机的最大占空比。 超过最大额定压力和/或工作循环的操作将导致空气压缩机损坏。