The function of a VIAIR “H” model compressor is to fill tires with the use of an air line and an open-end air chuck. All “H” model compressors come with an onboard ON/OFF switch and are equipped with a stainless steel braided leader hose with an open-end quick connect stud installed at the end of the hose. All “H” model compressors must be installed using the appropriate gauge wiring for the distance from the intended power source and must be properly fused to protect the unit and the vehicle it is installed inside of. Most VIAIR compressors are equipped with a thermal overload protector that will shut down the unit when overheated. When cool, the compressor will automatically restart as normal.
www.fulies.com
Note: • Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the air compressor. Always observe the MAXIMUM DUTY CYCLE of the air compressor. Operation exceeding maximum pressure ratings and/or duty cycle will result in damage to the air compressor.

VIAIR“H”型压缩机的功能是使用空气管路和开口气动卡盘填充轮胎。 所有“H”型压缩机都配有一个板载ON / OFF开关，并配有一个不锈钢编织引导软管，在软管末端安装了一个开口快速连接螺栓。 所有“H”型压缩机必须使用适当的仪表接线安装，以确保与预期电源的距离，并且必须正确熔断以保护设备及其安装在其内部的车辆。 大多数VIAIR压缩机都配有热过载保护器，过热时会关闭设备。 冷却后，压缩机将自动重启。

注意：•始终在压缩机的最大压力等级或以下运行压缩机。 始终遵守空气压缩机的最大占空比。 超过最大额定压力和/或工作循环的操作将导致空气压缩机损坏。